[WT-support] TI5/CT1ILT Help with K3+Win-test

[Steef PA2A]

Felipe,

Don 't forget to put your K3 in the PTT mode by pressing and holding the VOX switch. Otherwise it won 't work.

Steef PA2A
  ----- Original Message ----- 
  From: Filipe Lopes 
  To: Pete Smith N4ZR ; Win-Test Reflector 
  Sent: Friday, February 14, 2014 3:42 PM
  Subject: Re: [WT-support] TI5/CT1ILT Help with K3+Win-test


  Hi again


  thanks for the answers. Nothing helped so far.


  changed cables and still the same.


  I guess will have to play like this.


  If anyone has any last minute suggestion I'll take it!


  thanks
  Filipe TI5/CT1ILT


  73's Filipe Lopes 
  CT1ILT, F4VPX, CR6K





  2014-02-14 12:29 GMT+01:00 Pete Smith N4ZR <n4zr at contesting.com>:

    Because Winkeyer operates entirely differently from serial port CW, I think you can rule out Win-Test as a source of this problem,. The Winkeyer receives ASCII from the serial port and forms the CW internally.  

    It is most likely a K3 setting issue, and a much better place for answers is the Elecraft reflector <elecraft at mailman.qth.net>.  BTW I would start by turning off K3 QRQ - that's intended for real QRQ, up in the 60-80 WPM range

73, Pete N4ZR
Check out the Reverse Beacon Network at 
http://reversebeacon.net, 
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite 
ARC V6 or VE7CC DX cluster node.
On 2/14/2014 3:33 AM, Filipe Lopes wrote:

      Hi guys,


      I am in Costa Rica and I am using a K3 with win-test and my notebook with WIN7 and when I increase speed over 34 36 WPM  the CW starts to get messy, some of the caracheters I send are almost unreadable, like C is almost Y.


      I changed Keyer, was using K1EL Winkey, then I tried CW via CAT cable, and then I have my own cable with a transistor and resistor and they all do the same.


      I tried unpluging the CAT system while txing with my cable keyer and still the same.


      I am using all USB TO RS232 converters that work well with my TS590.


      I have changed into CW QRQ in K3 menu.


      is there anything else I should look at?


      thanks a million for help


      73's Filipe Lopes 

      TI5W in ARRL CW




      CT1ILT, F4VPX, CR6K ​ ​



       

_______________________________________________
Support mailing list
support at win-test.com
http://lists.f5mzn.org/cgi-bin/mailman/listinfo/support






------------------------------------------------------------------------------


  _______________________________________________
  Support mailing list
  support at win-test.com
  http://lists.f5mzn.org/cgi-bin/mailman/listinfo/support
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.f5mzn.org/pipermail/support/attachments/20140214/76f11d5b/attachment.html>