[WT-support] Script for getting next call in Bandmap

[Bob Wilson, N6TV]

Olli,

You cannot write a Lua script to read a response from the radio.  You can
issue an "IF;" command to the K3, but you cannot read the results.

Maybe the problem is that once you switch VFO B, the frequency in the band
map changes, so Ctrl-Up is going to start from a new place.

One approach that may work better than swapping VFOs is to :

-- Save current VFO A frequency
local VFOAfreq = wtRadio:GetFreq(WT_RADIO_VFOA)

-- Press Ctrl-Up to move VFO A to new freq
wtApp:SendKeyCode(294, WT_KEY_CTRL)

-- Set VFO B freq to current VFO A freq
wtRadio:SetFreqSubVfo( wtRadio:GetFreq(WT_RADIO_VFOA) )

-- Restore original VFO A freq
wtRadio:SetFreq(VFOAfreq, WT_RADIO_VFOA)

-- No further keystrokes
return -1

You may have to add a wtApp:Sleep(100) to allow the radio to switch
frequencies.

On a K3 you could issue a command to do A->B directly (SWT13;).

I have not tested it, please report results.

73,
Bob, N6TV

On Fri, Nov 19, 2010 at 5:18 PM, Oliver Grossmann <
oliver.grossmann at bretzi.de> wrote:

>  Hello,
> I tried some stuff, but nothing seems to work. The cat command for the TRX
> works just fine for switching.
> The problem seems to be in time gap between setting TRX to 2nd VFO and
> WinTest getting confirmation of switching VFO from the radio.
>
> If I'm placing a wtApp:Sleep(n) the Programm will do nothing in this time,
> even not checking if TRX status has changed.
>
> I think i will try to get the status from the TS-850 by interpreting the
> return value of the IF command, or implement an delay from system time
> without stopping the WinTest Application.
>
> If someone has anymore hints i will be looking for this.
>
> Olli
>
>  ------------------------------
>   Oliver Grossmann   |   DH2WQ   |   oliver.grossmann at bretzi.de
>
> On 19.11.2010 20:00, Laurent HAAS - F6FVY wrote:
>
> Hi
>
> Le 19/11/2010 19:44, Bob Wilson, N6TV a écrit :
>
>
>
>  If I could figure out how to send up arrow and down arrow commands (key
> code?) from Lua
>
>
>  Try
>
> wtApp:SendKeyCode(294. 4) for the Ctrl-Up key
> wtApp:SendKeyCode(296, 4) for the Ctrl-Down key
>
> Not deeply tested.
>
> 73
>
> Larry - F6FVY
> _______________________________________________
> Support mailing listSupport at win-test.comhttp://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.f5mzn.org/pipermail/support/attachments/20101119/4a6b3f60/attachment.htm