[WT-support] WKUSB problem version 22

[Karel Odehnal]

Solved Bob!

There was bad configuration in standalone mode.

73! Karel OK2ZI

Bob Wilson napsal(a):
> There is not enough detail to diagnose the apparent configuration problem.
>
> It's sounds like the Win-Test PTT line is mixed up with the CW output.
>
> If you can't figure it out, please send screen shots of your Win-Test 
> SETUP and microHAM ports dialogs.
>
> 73,
> Bob, N6TV
>
> On Tue, Nov 16, 2010 at 10:46 AM, Karel Odehnal <odehnk at seznam.cz 
> <mailto:odehnk at seznam.cz>> wrote:
>
>
>     Hello all,
>
>     I have problem with WKUSB keyer (Winkey 2 chip version 22 inside).
>     This keyer can not work under WT. I tested him with N1MM, WKtest
>     and few
>     other SW with success but, not under WT.
>
>     (I have also microKeyer II with Winkey 1 version 10 - tested OK, MK2R
>     with Winkey 2 version 21 - tested OK)
>
>     I tried to change nearly everything in WT, but without success. WT
>     reads
>     the speed from the pot, keys the radio, but from the paddle is comming
>     only steady tone.
>     The same is going out after F1 pressing.
>
>     I am totally lost with this keyer under WT. What is wrong??
>
>     Thanks Karel OK2ZI
>     _______________________________________________
>     Support mailing list
>     Support at win-test.com <mailto:Support at win-test.com>
>     http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>