[WT-support] WKUSB problem version 22

[Bob Wilson, N6TV]

There is not enough detail to diagnose the apparent configuration problem.

It's sounds like the Win-Test PTT line is mixed up with the CW output.

If you can't figure it out, please send screen shots of your Win-Test SETUP
and microHAM ports dialogs.

73,
Bob, N6TV

On Tue, Nov 16, 2010 at 10:46 AM, Karel Odehnal <odehnk at seznam.cz> wrote:

>
> Hello all,
>
> I have problem with WKUSB keyer (Winkey 2 chip version 22 inside).
> This keyer can not work under WT. I tested him with N1MM, WKtest and few
> other SW with success but, not under WT.
>
> (I have also microKeyer II with Winkey 1 version 10 - tested OK, MK2R
> with Winkey 2 version 21 - tested OK)
>
> I tried to change nearly everything in WT, but without success. WT reads
> the speed from the pot, keys the radio, but from the paddle is comming
> only steady tone.
> The same is going out after F1 pressing.
>
> I am totally lost with this keyer under WT. What is wrong??
>
> Thanks Karel OK2ZI
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.f5mzn.org/pipermail/support/attachments/20101116/aebce06f/attachment.htm