[WT-support] Function Key Failure

[Ian Frith Broad Band]

Hi All

Well not cured the problem yet.

However I have carried out a few experiments.

1. All versions of WT 3 & 4 act the same way using Win 7 i.e. only the first 
CW character sent.
2. Dx base in Win 7 sends F1 etc messages ok.
3. HRD sends messages ok.

I don't use Micro Ham etc. Rig is IC756 Pro III, Same problem using IC-7000, 
Cheers for now

Ian G4GIR



--------------------------------------------------
From: "Simon Schelkshorn" <simon at schelkshorn.de>
Sent: Sunday, December 20, 2009 9:54 AM
To: <support at win-test.com>
Subject: Re: [WT-support] Function Key Failure

> Hi Bob,
>
> I don't think that it is the same problem as in the thread you
> mentionend. At least in my case nobody pressed the footswitch
> (sometimes it wasn't even connected). But it looks like it is the
> problem Nick has quoted. (@Nick: I will try typing setup the next
> time the problem occurs to see if WT also crashes here).
>
> I dont't want to confuse you but I've seen a similar problem when
> preparing for this years CQWWCW. At that time WT was sending two or
> three (don't remember exactly) characters which look like to be
> random and then stoped. The characters were the same during one
> session of WT, but changed sometimes after restarting WT/MK. Solved
> the problem by switching from WT 4.x (was the latest dev-Version at
> that time) to WT 3.27.1 (also latest dev). In this case I was using a
> K3, all other occurances have been with a TS850. In all cases I was
> using a MKII (latest FW and Router-Version, WinXP).
>
> 73, Simon (DJ4MZ)
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>