[WT-support] CW to SSB mode change problem

[Rick Dougherty NQ4I]

Hi Bob...I find that I have to hit the F1 key to get the sound card in the
voice mode..de Rick

2008/10/11 Robert Pack, NX5M <nx5m at txcyber.com>

>  Yes, my mic is plugged into my sound card.
> All of my settings are set up exactly as you described below.  I just
> verified this.
> I still have no input audio from the headset after I change from cw back to
> ssb.
>
> ----- Original Message -----
> *From:* Bob Wilson, N6TV <n6tv at arrl.net>
> *To:* support at win-test.com
> *Sent:* Friday, October 10, 2008 3:18 PM
> *Subject:* Re: [WT-support] CW to SSB mode change problem
>
> Did you check the two "Mute the microphone" check boxes in the Interface
> configuration (SETUP) screen<http://docs.win-test.com/wiki/Menu:Options#Configure_interfaces...>?
> If your mic. is plugged into your sound card, the last one should probably
> be *unchecked*.
>
> Also, Start, Control Panel, Sounds and Audio Devices, Audio tab
>
> Sound playback section
> Volume button, Microphone Slider, make sure to *uncheck* "Mute"
>
> Sound recording section
> Volume button, Microphone Slider, make sure to *check* "Select"
>
> 73,
> Bob, N6TV
>
> 2008/10/10 Robert Pack, NX5M <nx5m at txcyber.com>
>
>>  Upon testing the CTRL-F1/F2....same result.
>> However, I did discover that when I change from CW back to SSB, no matter
>> how I do it (CTRL-Fx or just do it on the radio), I still have no voice
>> input when I speak into the mic....however, if I press a F-message key it
>> transmits the recorded message.  After that, I have my vox audio back.
>> Seems pretty strange.
>>
>>  ----- Original Message -----
>> *From:* Bob Wilson, N6TV <n6tv at arrl.net>
>> *To:* support at win-test.com
>> *Sent:* Friday, October 10, 2008 12:14 AM
>> *Subject:* Re: [WT-support] CW to SSB mode change problem
>>
>>   Are you using WT 3.22?  I tried both WT 3.21 and WT 3.22 for an IARU
>> contest, but I could not replicate the problem.  Switching from CW to SSB
>> with Ctrl-F1 worked fine.  The F1 message plays back as expected.
>> Please send a screen shot of your SETUP menu (probably too big for the
>> reflector, so just send it to me).
>>
>> 73,
>> Bob, N6TV
>>
>> 2008/10/9 Robert Pack, NX5M <nx5m at txcyber.com>
>>
>>>  Setting up my first 3 stations and put them on the air for the first
>>> time tonight I discovered a problem.
>>> This happened on all 3 stations and Wintest was set up for a mixed-mode
>>> contest (IARU) in this case.
>>> Testing out ssb with a friend, we next went to cw.  Upon returning to ssb
>>> I could not transmit on ssb.
>>> I had to click OPTIONS>CONFIGURE INTERFACES>OK.
>>> After doing that, ssb audio came back to life.
>>>
>>> It seems as if the "enable soundcard" is being turned off and has to be
>>> turned back on again after changing from cw back to ssb although when I open
>>> the config window it shows to be still turned on.
>>>
>>> I would think that this would have been discovered during a past IARU
>>> contest in which someone was doing mixed mode.  Or perhaps this is just
>>> something recent OR I have overlooked something.
>>>
>>> I have yet to find anything that will tell me why this is happening.
>>>
>>>
>>>
>>> 73,
>>> Bob NX5M
>>>
>>> _______________________________________________
>>> Support mailing list
>>> Support at win-test.com
>>> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>>>
>>>
>>  ------------------------------
>>
>> _______________________________________________
>> Support mailing list
>> Support at win-test.com
>> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>>
>>
>> _______________________________________________
>> Support mailing list
>> Support at win-test.com
>> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>>
>>
>  ------------------------------
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.f5mzn.org/pipermail/support/attachments/20081011/a5dbb013/attachment.htm