[WT-support] No spots on WT

[Bernhard Buettner DL6RAI]

Tom:

- Start with WT DX Telnet. Will it connect to the server and 
  show current DX spots?
- Next, in Win-Test make sure you have networking enabled 
  (Options | Interfaces Configration | Enable ethernet network).
- Next, verify you have the correct network settings both in 
  WT DX Telnet and Win-Test. The Broadcast Address needs to be 
  identical on both sides.

Refer to: http://docs.win-test.com/wiki/DX_Cluster/Telnet#Configuring_wtDxTelnet_.28single-op_environment.29

Good luck!

Ben, DL6RAI

> I have a problem with WT cluster. It was working fine until 24 Dec. 
> After that time, when I bring up the program, it connects to telnet, but 
> the dxcluster page shows all the old spots from 24 Dec. I tried to 
> re-install several times with no success. I am using Vista and 
> downloaded the trial version; used 'run as admin' and inputted the reg 
> key. Now I get only a 'black screen' on dxcluster even though telnet 
> shows me connected and spots coming thru. Yes, I did go to the profile 
> page and chose single op assisted.
> Any suggestions appreciated.
> 73
> Tom
> CX7TT
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>