[WT-support] AFSK setup help for K3 please

[mm0gpz]

Erwin.

Thanks for that. I had imagined I was missing a setting in WT and
didn't have to use LP Bridge.

So thanks, now using LP Bridge, Com 13 setup for use with MMTTY to PPT
only, and WT rig control running fine off another virtual port Com 4.
All OK now.

BTW, VOX was not a good solution as you said. I found very strong
signals would make the K3 go to TX even with the VOX gain set to where
it just made VOX key correctly.

73

Gordon

Using VOX is not a good and not a save way for keying.
Have you tried RTS/DTR different settings ?
If you have more than one software using com ports try LP-PAN. That
creates virtual cpm port based on one serial.
Since I use that I never had problems with keying.
73's Erwin/DK5EW