[WT-support] Swap Radio&MK2R+

[Clive Whelan]

Thanks Juha.

Yes you are right that this bug occurs when the dual footswitch is 
enabled in router- well spotted!


However in my case this is not a mistake as I duse the dual 
footswitches. I know for sure that the problem does NOT occur when using 
N1MM logger, so I believe the issue is with the WT code. I am not a 
programmer of course, so I'll pass along the info to the mH support team 
and hope that they can solve it with the WT team

73


Clive
GW3NJW

oh1jt wrote:
> Hi,
> We had the same problem at oh2u station during sac ssb test. I found the 
> problem. In our microham router software the so2r tab was configured 
> wrong. The dual foot swich was active. Just disabled it and then the 
> software and microham started to behave,,
> gl
> juha
> oh1jt
> Clive Whelan kirjoitti:
>   
>> This "bug" has been driving me nuts for a while now. At least I now know 
>> what is happening, but why remains a mystery.
>>
>> In contests the command has been working just fine, but outside thereof 
>> it has not. What happens is this:
>>
>> Pressing the swap radio key changes the tx focus but NOT the rx focus. 
>> In this scenario I am using the paddle and the internal Winkey in the 
>> MKR2+. However if I then press a programmed F key ( say F4 to send my 
>> call), then thereafter the swap radio key changes both tx and rx focii . 
>> Perhaps I'm wrong but I can only surmise that this is a bug in the code 
>> somewhere.
>>
>> 73
>>
>>
>> Clive
>> GW3NJW
>> _______________________________________________
>> Support mailing list
>> Support at win-test.com
>> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>>
>>   
>>     
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>
>