[WT-support] Splits on 40

[Robert Pack, NX5M]

It did not matter if the qso was logged or not.
  ----- Original Message ----- 
  From: Bob Wilson, N6TV 
  To: support at win-test.com ; Robert Pack, NX5M 
  Sent: Saturday, October 25, 2008 8:54 PM
  Subject: Re: [WT-support] Splits on 40


  Bob,

  I can't replicate this problem with WT 3.23 and K3 radios.  Double-click on a 40m spot in the band map, a spot with an asterisk (*), the radio goes into SPLIT mode, DX frequency to VFO A, and the split frequency is set properly in VFO B.  Double click on a spot with no asterisk, radio exits SPLIT mode and VFO A is set to the DX frequency.  It doesn't matter what order I click on these spots, it always works as expected.

  I didn't try logging any of these spots though.  Does simple clicking on band map spots work or not?

  Make sure your rig (FT-1000MP?) isn't in MEM TUNE mode on VFO A.

  73,
  Bob, N6TV


  2008/10/25 Robert Pack, NX5M <nx5m at txcyber.com>

    Operator here noticed the following:

    Clicking on a spot in the bandmap which has a split works.
    But, when he clicks on the next spot which has a split (the freq of the dx) the radio does not go to that frequency.  Radio does not go to the transmit freq of the dx.
    If he clicks on a call that is not a split, AFTER working a call that was a split, the next time he clicks on a split it works.

    This is a bit hard to put into words...sorry.



    73,
    Bob NX5M

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.f5mzn.org/pipermail/support/attachments/20081026/0569049c/attachment.htm