[WT-support] Splits on 40

[Denny Sahovic, KX7M]

On FT1000D, I had to turn off SPLIT on the radio, and then 
double-clicking on the spot (with SPLIT info) worked.

Denny, KX7M


Bob Wilson, N6TV wrote:
> Bob,
>
> I can't replicate this problem with WT 3.23 and K3 radios.  
> Double-click on a 40m spot in the band map, a spot with an asterisk 
> (*), the radio goes into SPLIT mode, DX frequency to VFO A, and the 
> split frequency is set properly in VFO B.  Double click on a spot with 
> no asterisk, radio exits SPLIT mode and VFO A is set to the DX 
> frequency.  It doesn't matter what order I click on these spots, it 
> always works as expected.
>
> I didn't try logging any of these spots though.  Does simple clicking 
> on band map spots work or not?
>
> Make sure your rig (FT-1000MP?) isn't in MEM TUNE mode on VFO A.
>
> 73,
> Bob, N6TV
>
> 2008/10/25 Robert Pack, NX5M <nx5m at txcyber.com <mailto:nx5m at txcyber.com>>
>
>     Operator here noticed the following:
>      
>     Clicking on a spot in the bandmap which has a split works.
>     But, when he clicks on the next spot which has a split (the freq
>     of the dx) the radio does not go to that frequency.  Radio does
>     not go to the transmit freq of the dx.
>     If he clicks on a call that is not a split, AFTER working a call
>     that was a split, the next time he clicks on a split it works.
>      
>     This is a bit hard to put into words...sorry.
>      
>      
>      
>     73,
>     Bob NX5M
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.f5mzn.org/pipermail/support/attachments/20081025/3bc2e4f6/attachment-0001.htm