[WT-support] S&P V3.14.0

[Baker]

>>> I expected that if I changed the radio frequency by greater than the
>>> Frequency
>>> Change Threshold that the call I had manually entered would be
>>> transferred to
>>> the Bandmap  display and the entry line wiped. This does not happen.
>>>
>>
>> Affirmative, that should work like you described as far as the S&P mode
>> is enabled. In RUN mode, nothing happens when you change the frequency.
>> I have confirmation from some users that it works that way, at least for
>> the primary radio (= active radio).
>>
>> Can you please verify again? If you are still not able to get it
>> working, could you send me direct to my home email adress your WT.INI file?
>>
>> Thanks and 73,
>>
> My TT Orion II doesn't work that way either!
> Setup: Orion II and microKeyer (firmware 3.2 and USB device router ver.
> 4.0.10)
>
> 73
> Joe, DL4CF

I am also using a microKeyer (same firmware & software). Maybe there is a clue 
there.

73
Stewart G3RXQ
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support