[WT-support] No CW going to Radio B

[Tõnno Vähk]

I am happy to report that I got this problem and also Paddle problem solved!!

Fabio recommended me to install earlier firmware, I did it and everything started to work with EZM! So I re-installed 1.37 again and it also works. So just firmware was corrupted somehow.

Now even WinKey works although sometimes when WK is enabled there are some interruptions and distortions in sent CW and also the Iambic keying does not work correctly from paddle.

Thus I don't use WK and everything is OK!! Thanks Fabio!

73
tonno
es5tv

 

-----Original Message-----
From: support-bounces at win-test.com [mailto:support-bounces at win-test.com] On Behalf Of Tõnno Vähk
Sent: Saturday, May 13, 2006 3:27 PM
To: support at win-test.com
Subject: RE: [WT-support] No CW going to Radio B

yes, I have EZM 1.37 and WK 10

and this problem apprears only when WinKey is DISABLED like I wrote previously. Very strange.

Actually I believe I have problem with my EZM as paddle is not working in any mode correctly and CW is completely messed up when WK is enable thus I guess I have to try to replace it.

I was asking previously if it is possible to route paddle directly to WT through LPT port and thus EZM would not be in the circuit . could I do it? Is there an input for paddle to WT?

73
tonno
es5tv 

-----Original Message-----
From: support-bounces at win-test.com [mailto:support-bounces at win-test.com] On Behalf Of Olivier F5MZN
Sent: Saturday, May 13, 2006 2:53 PM
To: support at win-test.com
Subject: Re: [WT-support] No CW going to Radio B

Hi -

>  
> I have a strange problem and nothing seems to help.
>  
> Using 2xMP and EZMaster and WT in Advanced SO2R mode.
>  
> All the CW messages that I send go to A radio. Also when Active Radio 
> is B and also when I use SHIFT (SHIFT for binding is enabled).
>  
> When I have Active Radio A and press SHIFT+F1 for example then for a 
> half a second Active Radio changes to B (led flashes on EZM) but then 
> goes back to A and message starts on A.
>  
> When the Active Radio is B and I send message it goes straight to Radio A.
> After message is completed WT shows that Active Radio is B but EZM shows A.
>  
> No change of WT version or restarting computer/EZM seems to help. Also 
> the same happens in simple SO2R mode using empty scenario does not help.
>  
> This all happens when WinKey is disabled. Now when I enable WK then 
> the problem is fixed and messages go to Radio B when they are supposed 
> to go there.
>  
> And also very strange is that with SSB messages there is no problem - 
> they go to B radio always when supposed to.
>  
> Can anybody help?

Have you got the last available firmware in your EZM?

Have you tried either with or without WinKey?

73 de Olivier / f5mzn
--
A: Because it messes up the order in which people normally read text.
Q: Why is it such a bad thing?
A: Top-posting.
Q: What is the most annoying thing on usenet and in e-mail?
_______________________________________________
Support mailing list
Support at win-test.com
http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
_______________________________________________
Support mailing list
Support at win-test.com
http://www.f5mzn.org/cgi-bin/mailman/listinfo/support