[WT-support] cw problem

[RIFAT TULTAK]

Tnx  Bob,

Problem solved.
Commands > cw weight ''3''  (my setup ''2'')

73 GL
TA2SE

Bob Wilson, N6TV <n6tv at arrl.net>, 9 May 2021 Paz, 06:16 tarihinde şunu
yazdı:

> Use the text command WEIGHT in the logging window to adjust dot/dash ratio.
>
> Use SETUP command to increase Keying Compensation if every element is too
> short by fixed amount of milliseconds.
>
> Set Windows 10 Control Panel, Power Options to "High Performance" if
> needed.
>
> 73,
> Bob, N6TV
>
> On Sat, May 8, 2021, 8:08 PM RIFAT TULTAK <rifattultak2 at gmail.com> wrote:
>
>> Hello,
>>
>> The rates of cw code signal sent from the software are not good. Point 1,
>> Line 3 rate is not good. Line short. How can i fix this. Thanks for the
>> answer.
>> 73
>>
>> TA2SE
>> _______________________________________________
>> Support mailing list
>> support at win-test.com
>> http://lists.f5mzn.org/cgi-bin/mailman/listinfo/support
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.f5mzn.org/pipermail/support/attachments/20210509/e1d60eaa/attachment.html>