[WT-support] Yaesu G-1000DXC rotator and ZLP Electronics GS232 controller

Steef PA2A pa2a at xs4all.nl
Sat Dec 5 23:13:15 CET 2020


Hi,

I have the ZLP Electronics GS232 rotator controller working on a brand 
new Yaesu G-1000DXC rotator. I had to define the rotator as a K3NG 
rotator. Tnx to Bob N6TV who suggested this K3NG rotator definition it 
works fine now.
In wtRotators the Yaesu protocol uses 4800 baud where the ZLP interface 
only works at 9600 baud.

The G-1000DXC can rotate from 0 to 450 degrees. Does anyone have a 
setting where it is possible to use the overlapping range from 360 to 
450 degrees for the Yaesu G-1000DXC, in combination with the ZLP RS232 
interface?

73s Steve PA2A


More information about the Support mailing list