[WT-support] Slow response in bandmap

[gt-i at gmx.net]

Bob,

there was no other program oder device polling the K3. Instead, I 
discovered my WinKey (via microham) was running at 1200bd instead of 
9600. I have no clue how that happened, but now the response delay is gone.

73, Gernot, DF5RF


Am 06.05.2017 um 23:42 schrieb Bob Wilson, N6TV:
> This is commonly caused by too many programs trying to poll the radio 
> at the same time, perhaps with a slow baud rate.
>
> Exit all copies of NaP3 and any other program that may be polling the 
> radio (Elecraft K3?) at the same time as Win-Test.  I'm sure if you 
> reboot the computer and radio, everything will be back to normal.
>
> For now, do *not* set CONFIG: AUTOINF to AUTO 1 or AUTO 2 unless you 
> /have/ to for a SteppIR or similar.
>
> 73,
> Bob, N6TV
>
> On Sat, May 6, 2017 at 2:33 PM, <gt-i at gmx.net <mailto:gt-i at gmx.net>> 
> wrote:
>
>     Running Wt 4.24.
>
>     Until today everything worked fine - hmm. Now, an update in the
>     frequency takes about 1-2 seconds to show up in the VFO A display
>     of the bandmap, and 2 seconds more until the needle of the band
>     map jumped to the new frequency. If I enter a call sign before
>     that jump, it will show up in the wrong place.
>     I connected the TRX to a terminal program to check the connection
>     - works immediately. Also, NaP3 follows immediately.
>     I wonder if there is any setting int WT which I could have messed
>     up somehow?
>     tnx for help,
>     Gernot DF5RF
>
>
>     _______________________________________________
>     Support mailing list
>     support at win-test.com <mailto:support at win-test.com>
>     http://lists.f5mzn.org/cgi-bin/mailman/listinfo/support
>     <http://lists.f5mzn.org/cgi-bin/mailman/listinfo/support>
>
>
>
>
> _______________________________________________
> Support mailing list
> support at win-test.com
> http://lists.f5mzn.org/cgi-bin/mailman/listinfo/support