[WT-support] RUN and S&P

[Bob Wilson, N6TV]

On Thu, Dec 7, 2017 at 2:49 AM, Pierre <pirobet at gmail.com> wrote:

> Is there any possibility on WinTest to automatically switch from RUN to
> S&P when you click on a call in the bandmap.
>

Not really, unless you are using two radios and the secondary radio is in
S&P mode, and you click on the band map for the second radio.

Of course it's only important to switch to S&P mode if you're using Enter
Sends Message (ESM) mode.  Is that what you are doing?

Is it possible to remove off the bandmap the stations you alredy worked.
>

If you use the Bandmap's List view (click the *List* tab at the bottom of
the window) instead of the default *Bandmap* view, right click on the
window, select "Display Options", and then "Hide dupes and invalids".  This
does not delete the spots, but it hides them from view.  But it only works
in the List view.  There is no corresponding option in the Bandmap view,
because most people use the bandmap view while tuning manually with a knob,
and it's helpful to identify all stations as you scroll past the frequency,
even dupes.

You can delete bad spots or unwanted spots, one at a time, in three
different ways:

   1. Right Click on a spot, Left click on Delete, left click on "OK" when
   prompted "Do you really want to delete?
   or
   2. Hold down the Alt key and double-click on the spot
   or
   3. Tune to the frequency of the spot until the call is highlighted in
   yellow (or double click on it), then press Ctrl-Delete to remove it from
   the band map.

73,
Bob, N6TV
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.f5mzn.org/pipermail/support/attachments/20171207/4e133540/attachment.html>