[WT-support] Win-Test v 4.10, IC-7800 and RigExpert Standard - now CW

[Bob Wilson, N6TV]

   1. In Win-test, type NOSOUND [Enter] in the logging window to prevent
   distorted CW from sounding on the PC speaker (it will also make the keyed
   CW sound better).
   2. Run Start, Programs, RigExpert Standard, Show Serial Ports
   3. Note which COM port has been assigned for CW and PTT
   4. Type SETUP [Enter] in the Win-Test logging window
   5. Put a check mark next to the COM port that RigExpert is using for
   CW/PTT
   6. Set the device type on that line to "Other Interface"
   7. Press the Configure button on that same line to configure the COM port
   8. Set DTR (pin 4) to CW and RTS (pin 7) to PTT
   9. Click OK
   10. Click OK again
   11. Test F1 for CW

If you still get no CW output, make sure the IC-7800 is in CW mode, and
make sure there is cable connected from the RigExpert transceiver cable to
the KEY jack line on the back of the IC-7800.  Do not plug it into
"ELEC-KEY," which is for paddles.

Also make sure nothing in Win-Test is set to "WinKey" and that the LPT
keying option is not checked.

73,
Bob, N6TV

On Tue, Sep 24, 2013 at 4:28 PM, Anton Koval, MW0EDX <m0edx at yahoo.com>wrote:

> I mean no CW out on my IC-7800...Band change is OK via cluster.
>
>
> Anton Koval
> m0edx at yahoo.com
>
>   ------------------------------
>  *From:* "Anton Koval, MW0EDX" <m0edx at yahoo.com>
> *To:* "support at win-test.com" <support at win-test.com>
> *Sent:* Wednesday, 25 September 2013, 0:14
> *Subject:* [WT-support] Win-Test v 4.10, IC-7800 and RigExpert Standard -
> now CW
>
> Hello,
>
> Could anyone help, please.
>
> I was able to set Win-Test v 4.10, IC-7800 and RigExpert Standard a
> contest and cluster bank changes. But when I attempt to use F1 for CW
> messages out, I can only hear some distorted CW om my PC speaker.
>
> Spent a few hours changing COM configuration - nothing.
>
> Frustrated indeed...
>
> Can anyone help ?
>
> Thanks,
>
> Anton Koval, MW0EDX
>
> m0edx at yahoo.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.f5mzn.org/pipermail/support/attachments/20130924/feca2e85/attachment.html>