[WT-support] Ver 4, SO2R, WinkeyerUSB

[Tom W8JI]

I'm sorry to see the winkeyer interface was not corrected 
but I expected it would not be corrected. CW is low 
priority. :-)


----- Original Message ----- 
From: "Frank Steinke" <frank at dl8waa.de>
To: <support at win-test.com>
Sent: Thursday, July 23, 2009 2:53 PM
Subject: Re: [WT-support] Ver 4, SO2R, WinkeyerUSB


> Hank,
>
> same with 3.27. It seems that CW output goes over the KEY1 
> port always.
> It's a pity.
>
> cu
> 73 Frank DL8WAA
>
>
>
> hank.k8dd schrieb:
>> I set up NS Sprint to see how the "sprint logic" works 
>> .... and it's
>> good, which means I can understand it and make it work!
>> Then I tried SO2R.  Both the information for the K3 and 
>> the K2 show
>> up, but I can't switch radios on CW.  The display 
>> switches from Radio1
>> to Radio 2, but the WinkeyerUSB does not switch outputs.
>> Is this because of the lack of support for WinkeyerUSB?
>> 73    Hank    K8DD
>>
>>
>> -- 
>> "I knew that God put me on this earth to be on the 
>> radio."    Ed Bradley
>>
>> "Me too!"    K8DD
>> -
>> ------------------------------------------------------------------------
>>
>> _______________________________________________
>> Support mailing list
>> Support at win-test.com
>> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>>
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>