[WT-support] CW characters lost when footswitch is pressed

[Bob Wilson, N6TV]

On Sat, Dec 5, 2009 at 1:32 AM, Patrick Egloff <pegloff at gmail.com> wrote:

> I saw this setting.
>
> But CW is made by Winkey builtin microkeyer... i do not produce serial CW.
>

In the microHAM documentation, where it says "serial CW", they mean "WinKey
CW."  ASCII characters and commands are sent to the Winkey via a virtual *
serial** port* interface.  The WinKey translates these characters to CW.

"Serial CW" in this case is *not* serial port on/off CW keying via DTR or
RTS.

The "mute" lasts only a few signs, not all time i keep the footswitch
> close...
>

It is working as documented.  In the Router software, you need to *uncheck
the box *marked *Mute serial CW*.  It should fix the problem you describe.
 Please try it.

73,
Bob, N6TV
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.f5mzn.org/pipermail/support/attachments/20091205/6a73609e/attachment.htm