[WT-support] TS950SDX

[Andrew Hewitt]

Sorry an error crept in there - it is only one TS950SDX, the other rig is a
TS570 and that does not have the problem.

73

Andy G3SVD

 

 

  _____  

From: support-bounces at win-test.com [mailto:support-bounces at win-test.com] On
Behalf Of Andrew Hewitt
Sent: 07 January 2008 17:08
To: WIN TEST
Subject: [WT-support] TS950SDX

 

 

Is any one using WinTest with the above rig? I would appreciate some advice.

 

I am trying to get WinTest functioning with my two Kenwood TS950sdx, it
seems to be almost there but not quite. The CAT problem is that there seems
to be almost no control of the rig's frequency. On the band map display, for
example, I have VFO A set to 3752 and B set to 14046; the active VFO will
indicate the correct frequency, whichever is selected but the inactive one
shows either 7,020 or 28,400. Putting a call into the band map on a
different frequency and then clicking on it, the mode changes to the correct
mode but the frequency stays the same.

 

I am using the same com port for keying via DTR. That works OK. I suspect
that there is a minor setting wrong. I have the following settings 4800bps,
8 data bits, no parity and two stop bits. DTR is cw and RTS is off (I have
tried it with this on with no effect).

 

Thanks for any advice in anticipation

73

Andy G3SVD

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.f5mzn.org/pipermail/support/attachments/20080107/4f5e027c/attachment.htm