[WT-support] WT 3.0 and Rtty in Wae Qtc-Window

[Werner Maier]

Hi,

> Ok Werner i know the rules.... but again when i open
> the RX-Qtc-Window or the TX-Qtc-Window i can not send
> the buttons    F1=QTC? / F2=QRV [...]
> The buttons are not aktive in both windows!!!

You are right, pressing those buttons does something
in windows (i.e. can be selected, clicked on, You can see
they're pressed) but nothing happens in MMTTY.

(contrary to pressing F1 in normal log mode, there is a CQ
in MMTTY.)

also the QSO-Points seem wrong - WT counts EU with 0 Points,
but you are allowed to work everybody, so this should count 1 point.

> To send a Qtc to a DX-Station, WT search only DX-Calls no EU-Calls!!
> Is this right???
> I think we can send each Qso as a Qtc??

I think You're correct, in RTTY, every QSO should go as a QTC.
only QTC Traffic is across continents, but this does not tell
something about which QSOs count as QTC and which do not.

> 13 Special Rules for RTTY:
>
> In the RTTY portion of the WAEDC there are no continental limits;
> everybody can work everybody. Only QTC traffic must be performed
> between different continents.

I think this implies that an EU can give a QSO with other EUs as a QTC
to any DX.

Another Problem: You cannot set RTTY-Messages in WAEDC if you select
RTTY - because Options/CW is disabled and so You can not set the
messages.

But till WAEDC-RTTY there is some time, and I guess they'll fix it :)

Werner.
--
Dipl.-Ing. Univ. Werner Maier
http://www.maiers.de/