Fw: [WT-support] VERSION 2.20.0

[Don Beattie]

Sorry - I wrote this before I upgraded. Now I have the new EZM firmware, I 
am using the latest v 2.20 of WinTest.

Don


----- Original Message ----- 
From: "Don Beattie" <g3ozf at btinternet.com>
To: <support at win-test.com>
Sent: Tuesday, November 29, 2005 11:15 AM
Subject: Re: [WT-support] VERSION 2.20.0


> Oliver,
>
> It is the same in advanced or normal SO2R
>
> If I set up a contest, set the mode as SSB, the latch works fine.
>
> If I go to the contest set-up and change it to CW, it stops the latch
> working. No change-over of rx either from foot switch or paddle or 
> function
> key messages.
>
> I checked setting up a contest from start in CW - same effect. But I can
> cure it by resetting the mode to SSB
>
> I'm using v2.19.3 and dev updated 2.20, with EZM.
>
> Any ideas ?
>
> Don, G3BJ (and G5W)
>
>
> ----- Original Message ----- 
>>
>>> I also have another problem which is on both 2.19.3 and 2.20 (but which
>>> may be an EZM problem). If I set up an SSB contest, I can use the
>>> headphone latch facility OK. If I set up a CW contest, the headphone
>>> latch does not work either with the foot switch or when sending from
>>> either the paddle or the function keys. Whilst this may be an EZM
>>> problem,  if others have the same problem perhaps there is something
>>> wrong ?
>>
>> Is the SO2R advanced mode in use?
>>
>> 73,
>> -- 
>> Olivier / f5mzn
>> _______________________________________________
>> Support mailing list
>> Support at win-test.com
>> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>>
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
>